slenderness ratio

fine singular points cervical radiculopathy uniaxial compression characteristic of rock specimen in different slenderness ratio

不同长细比岩柱单轴压缩特性试验研究

互联网摘选

moreover, the influence of initial crookedness would be reduced as slenderness ratio and bending moment are increased.

初弯曲对杆件的影响随长细比和弯矩的增大而减小；

互联网摘选

This paper takes a large slenderness ratio spin rocket with a low spin velocity for example, and the launch dynamic behavior of the system is investigated when there is a clearance between the missile and the launcher.

以大长径比低速旋转火箭为例，探讨弹-架间隙非线性特性对不同发射装置系统的动力响应的影响。

互联网摘选

It was found that, in general, ascending time ratio, fire load ratio, cross-section dimension and slenderness ratio have a significant influence on residual strength.

得出结论：升温时间比、火灾荷载比、截面边长以及长细比是影响火灾全过程作用后圆钢管混凝土柱剩余承载力的主要影响参数。

互联网摘选

carbon nanotubes ( cnts) have been introduced as an ideal reinforcement phase of composites by their virtues of small diameter, high slenderness ratio, and outstanding physical and chemical properties.

碳纳米管（CNTs）管径小、长径比大、物理和化学性能优异，是复合材料的理想增强相，也成为新型铝基复合材料开发和CNTs应用研究的热点。

互联网摘选

The influence factors on the effective length factor such as the base plate thickness, the slenderness ratio, column section size and elastic modulus of concrete were studied based on the calculation of effective length factor of the specimen.

在对试验试件柱计算长度系数进行计算的基础上分析了底板厚度、柱截面尺寸、长细比以及混凝土弹性模量对计算长度系数的影响。

互联网摘选

The results show that the plastic extension would not occur in tensile region until eccentricity is large and slenderness ratio is small.

研究结果表明：除相对偏心率很大及长细比很小的情况外，工字形截面偏心压杆受拉翼缘不会进入塑性状态；

互联网摘选

experimental investigation of aft-end ignition for high slenderness ratio and small-size solid motor

大长细比小型固体发动机后点火试验研究

互联网摘选

μ m, the slenderness ratio of less than 2 ∶ 1, the single particle of water and gypsum ratio is 0.22 and 3-days compression strength reached 61.1? MPa of alpha hemihydrated gypsum.

制备了二轴平均径12.5μm、长径比2∶1、单一粒径水膏比0.223、d抗压强度达到61.1MPa的α半水石膏。

互联网摘选

research on modified coefficient of slenderness ratio of angle member in compression

受压角钢杆件长细比修正系数研究

互联网摘选

The resista nce decreases intensely when the slenderness ratio of the hot molding sand layer increases.

阻力随干砂层长细比的增加而急剧减小.

互联网摘选